Home Forums Technical Support Metal Finishing Finishing Bare Aluminum

Tagged: 

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • bart cocchiolaBarchiola
    Participant
    Post count: 7

    Hi Folks,

    I’m new to Stewart Systems and could use some guidance regarding aluminum prep. What I’ve got is a set of Citabria wings that are being converted to aluminum spars. The ribs are untreated and in very good condition. The new spar parts are bare, polished (not shiny but nicely finished) aluminum.

    It was recommended to me that the spars be primed (DuPont VariPrime was suggested) before assembly and any holes or scratches be dressed before covering. I’ve decided to use Stewart Systems for the covering but haven’t considered SS metal finishing products.

    Can someone please go through the options step by step? The goal of the project is to have a safe and soundly flying airplane, not a museum piece so I’d prefer to not strip and seal every last aluminum part like factories might do for corrosion proofing.

    Thanks in advance for the help! I guess I’ll shop for a couple of garage heaters while I figure this out. 🙂

    Bart

    bart cocchiolaBarchiola
    Participant
    Post count: 7

    Disregard

    bart cocchiolaBarchiola
    Participant
    Post count: 7

    OK, so I remembered reading something in the user manual and found this

    Aluminum Surfaces ? Clean all surfaces with STEWART
    SYSTEMS EkoClean Heavy Duty Cleaner (E670),
    followed by STEWART SYSTEMS EkoEtch
    (E675). The EkoEtch may be applied while the
    aluminum is still wet from rinsing the STEWART SYSTEMS EkoClean
    Heavy Duty Cleaner. Use a red Scotch Brite pad and remove the glaze from
    the aluminum. Let the EkoEtch work for 3-5 minutes; do not let EkoEtch
    dry on the aluminum surface, rinse with clean water. Remove excess water
    with compressed air. Prime with STEWART SYSTEMS one part
    Primer/Sealer (E75XX) or EkoPoxy (E76XX) when aluminum is completely
    dry, or within 12 hours of using the EkoEtch.

    What are the benefits/limitations of stopping after the one part Primer/Sealer? Is the EkoPoxy more of a finished coat for parts that will be visible after the plane is done?

    Would a household water supply with some mineral content (not very hard water but not soft either) qualify as “clean water” for the rinse?

    Is there a minimum temperature for the wash and etch steps where I’d likely have to be outside as opposed to in my heated shop?

    Thanks! I’m (slowly) making progress here.

    Duan YnaDuan Yna
    Participant
    Post count: 1

    manticonvert

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.